![\"Current](\"http:\/\/www.sonicpenguins.com\/blog\/wp-content\/uploads\/2006\/08\/2006-08-18-6980-current-state-of-affairs.JPG\")
<\/a><\/p>\nI’ve no idea how my right cannon got abused to end up like this. The small arm that connects to the gearbox must have been wrenched off. There’s still a small chunk of it left on and the split pin is still in there. I hammered out the split pin (it was stuck fast!) and fitted the new arms, with pretty much zero effort… if only I had the drive plate!!<\/p>\n
I ordered the drive plate from illinoispinball.com last saturday. So far my order status is still “processing”. I tried calling them but there’s just a voicemail that says there is no-one to answer your call.. then it disconnects! You can’t even leave a message! and yes I’ve been trying to call them at sensible american time times. What also makes me suspicious is that my order number is 132. That doesn’t sound like a lot!<\/p>\n
So out of frustration with illinois pinball I decided today to create my own drive plate! All be it a temporary one, while I’m waiting for the real deal to arrive.. so not a permanent solution, but they seem to be taking their jolly old time, so perhaps something that might last a month or two. To do this here were my weapons of choice:<\/p>\n
A cd case, a permanent marker and a junior hacksaw. At the bottom is the left drive plate. So I need to make a mirror copy of it. I yanked off the cd outer case and traced round the left drive plate.<\/p>\n Looking pretty snazzy huh? \ud83d\ude09 Next I cut it out with the hacksaw. This is a LOT harder than it sounds. Because it’s plastic it’s extreamly brittle. If you saw too hard it shatters into tons of tiny bits, so you have to saw really gently. Also you can’t do curves very easily, so I just cut straight edges, then I used very fine sandpaper to make the curve and smooth off the edges left by the hacksaw. The result:<\/p>\n One pretty similar looking right drive plate! Cutting out the square hole was a right pain in the arse. I thought about using a stanley knife, but then I decided to drill it out. I got a block of wood to drill against and used masking tape to stick the plastic plate down, then I used my smallist drill to cut tons of tiny holes in the square. It worked pretty well. After a bit of wiggling the drill the center section fell out and I had a rough hole with lots of circle edges, so I put a tiny piece of sandpaper on\u00a0a cable tie and used it to sandpaper out the square. It worked really well! As I was doing it, I was holding it up against the cannon base to see where to sand. Once I was done it was a perfect fit! \ud83d\ude42<\/p>\n Next I had to make the post, where the cannon arm attaches. I drilled a hole for a screw to go through, then thought about what to make the post out of.. I needed small frictionless plastic tube… Then I realised that I get posted them all the time! Free charity pen! I cut a bit to the right length and put it over the screw.. it wiggled a bit too much, so I took it off and wrapped masking tape around the screw until the pen cylinder fit perfectly around it \ud83d\ude42 Then finally on the original drive plate the post has a raised bit at the base, so for that I sawed off a tiny bit of wood from a stick I had lying around, drilled out the center and used a stanley knife to cut it into a rough circle. Ta Dar, the finished product! The wood square is used to go on the top of the screw to hold the cannon arm on.<\/p>\n Cool huh! But.. does it work?…<\/p>\n …..<\/p>\n ..<\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n